All Reports for Bug #50
The following reports have been identified as duplicates of #50 When i use a Stamper after a furnace, select the parts i want to be remove fr....
5mo
The Stamper doesn't block when the cut-out line is full. == Normally machines...
The Stamper doesn't block when the cut-out line is full.
==
Normally machines like the Cutter stop when the line behind them is full. Given this pattern I would expect that machines that have two o...
5mo
Discord Bot
Stamper Output Issue: Connected and Unconnected Outputs Diverge
https://clips.twitch.tv/DepressedExpensiveSpiderDoubleRainbow-ozvs79kab0j3Dl4F
Good evening.
I just noticed that the stamper isn't working correctly.As you can see in the clip, it divides the piece...
5mo
When using the Stamper, it does not check if its primary output is full. If i...
When using the Stamper, it does not check if its primary output is full. If it is or no belt is connected to the primary output, it still outputs the stamp remains out of the secondary, making the ...
5mo
I have two belts going into two stampers respectively. the main output of bot...
I have two belts going into two stampers respectively. the main output of both stampers are stopped due to end of belts. Even though the belts AFTER the stampers are stopped, the entire belt/assemb...
4mo
During my gameplay, while I build the Ultra Mech Assembly Line, I used an Adv...
During my gameplay, while I build the Ultra Mech Assembly Line, I used an Advanced Stamper to separate parts the I am going to use from another possible use. However, after configuration, I observe...
5mo
the stamper just keeps working, even if one output is blocked by a filled up ...
the stamper just keeps working, even if one output is blocked by a filled up conveyor; this should not be possible and makes the scrapper kind of obsolete
---
**Attached Files**
**Screenshot/Video...